Concord Industries - Estate (Wall-Mounted) Installation Instructions

Estate (Wall Mount) Installation

Your new Estate flagpole is of all-aluminum construction, and is finished with a fine-grain polish which will require no further care or maintenance. Both types of brackets, Vertical Wall Mount and Outrigger Wall Mount, are of cast aluminum, and are drilled for 3/8" fasteners of your choice (not included). We suggest that you use plated fasteners to guard against rust.

INSTALLATION:

First, determine the type of fasteners best suited for use on your wall (through-bolt mounting is preferred). Then, mount as instructed below:

Vertical Wall Mount:

There are two brackets to the set; the top bracket with a through-hole, the bottom with a cupped hole. Make a vertical mark on the wall where you want the brackets to be mounted. Line up the brackets on the mark, 18" to 24" apart. Drill holes for your type of fasteners, and mount brackets.

Outrigger Wall Mount:

There is one bracket with four 3/8" holes for the fasteners. Line-up bracket vertically, mark hole positions, drill and mount bracket.

ASSEMBLY:

Screw ball-stem tightly into top of truck. using a wrench to tighten jam-nut against the truck.

Thread halyard rope through truck pulley and tie flagsnaps into place using a simple overhand knot (knots can be adjusted later to fit the size flag being flown.) Tie halyard rope-ends together using a square-knot.

Mount truck assembly (including ball and halyard) on top of flagpole using an Allen wrench to tighten set-screws.

The aluminum cleat may be fastened to the flagpole with the screws provided. If you prefer, it may be fastened to the wall below the flagpole with fasteners of your choice.

Slide flagpole butt into brackets making certain that the shaft goes in as far as possible. Align shaft so that truck faces forward or down. Tighten set screw with an Allen wrench to prevent shaft from shifting.